Use this dialog to specify settings for an interface. These settings vary depending on board manufacturer, and are specific to interface boards. Keithley/CEC Instruments GPIB boards use the following settings:

ATEasy Board Address

Displays the ATEasy board address.

Board Index

Enter the board's index number. This is the board index used by the ATEasy interface driver to access the board.

Primary Address

Enter the board's GPIB primary address. Use this address when accessing the board from the internal driver.

I/O Address

Enter the board's I/O address. This setting must match the switch setting on the board.

IRQ

Enter the board's IRQ (interrupt request level). This is a number between 1 and 7, and must match the board's jumper setting.

Plug and Play

If the board is plug and play, click here.

OK

Click here to save your changes and close the dialog.

Cancel

Click here to discard your changes and close the dialog.