Use this dialog to specify settings for an interface. These settings vary depending on board manufacturer. , National Instruments (NI), Kysight/Agilent/HP SICL, and, and Measurement Computing (Computer Boards) Boards, GPIB boards use the same settings:
Displays the ATEasy board address.
Enter the board manufacturer Interface number - 0 through 100. This is used to form board descriptor: use 0 for GPIB0, 1 for GPIB1, etc. The number is used by the ATEasy interface driver to access the board. You can view the interface name in the GPIB manufacturer software (for example for National Instruments, open NI MAX and locate the GPIB interface number. Default is 0
For Keysight/Agilent/HP SICL boards, instead of the board index number, must enter the logical unit number that in between 1-300 range. This number should be copied from the Keysight/Agilent Connection Expert window.
Enter the board's GPIB primary address (usually 0). Use this address when accessing the board from the internal driver.
Click here to save your changes and close the dialog.
Click here to discard your changes and close the dialog.