DioReset

Applies To

GC5050, GX5050, GX5055, GX5150, GX5280, GX5290, GX5290e, GX5295, File

Purpose

Changes the state of the specified Master board to HALT and restores Master and Slaves to the default setup.

Syntax

DioReset (nMasterHandle, pnStatus)

Parameters

Name

Type

Comments

nMasterHandle

SHORT

Board handle.

pnStatus

PSHORT

Returned status: 0 on success, negative number on failure.

Comments

The following is the default setup:

GC5050, GX5050, GX5055, GX5150, GX5280, GX5290, GX5290e, GX5295:

  • Board is in a HALT state.

  • Program counter is set to 0.

  • Clock and Strobe are internal.

  • Default Clock:=10MHz.

  • Strobe timing = 10 nSec.

  • Trigger mode is disabled.

  • D, T and P mask register values are 0xFFFF.

  • D, T and P event registers are 0x0000.

  • External event source is external event lines (0).

  • X register value is 0.

GX5150:

  • I/O pins direction is set to Output.

  • I/O memory width is 32-bit.

  • External trigger transient level is set to low level.

  • Jump register A trigger mode is edge trigger.

  • Halt output mode is Hold Last.

  • Sequencer Overflow mode set to enable.

  • Clk Delay and Out Clock Delay are set to 12 nSec.

  • Pause Counter Mode is disabled.

  • StepCounter and Pause Count are zero.

GX5280/GX5290/GX5290e/GX5295:

  • Clk Delay set to 5 nSec

  • Strobe Delay set to 10 nSec.

  • I/O pins direction is set to Input.

  • External trigger transient level is set to low level.

  • Halt output mode is Hold Last.

Example

The following example resets the board:

 

SHORT   nStatus;

DioReset(nHandle, &nStatus);

 

See Also

DioHalt, DioInitialize, DioGetErrorString