GX5961, GX5964, File
Sets the sequence timeout value and output drivers’ states.
GtDio6xTimerSetSequencerTimeout (nHandle, dTimeoutValue, nState, pnStatus)
Name |
Type |
Comments |
nHandle |
SHORT |
Session identifier:● Board handle is used when communicating with the hardware. The Board handle session identifier is returned by calling GtDio6xInitialize or GtDio6xSetupInitialization. ● File handle is used when communicating with a file. The File handle session identifier is returned by calling GtDio6xFileOpen. |
dTimeoutValue |
DOUBLE |
Sets timeout, timeout is programmed in 20ns steps (may have an additional 20ns of error) with a range of 40ns to 85.899345940s. |
nState |
SHORT |
Used to specify if the timer’s timeout will affect the output drivers or not.0. GTDIO6X_DISABLED: A Sequencer timeout will not affect the output drivers. 1. GTDIO6X_ENABLED: A Sequencer timeout will cause all output drivers to will be disabled. |
pnStatus |
PSHORT |
Returned status: 0 on success, negative value on failure. |
This input control is used to specify the sequencer timeout count. The timeout timer will set bit 6 (WDTO) in the sequence event register if the sequence active time exceeds the specified value. The user can optionally disable the output drivers when the timeout status is true.
The following example sets the timeout value of the sequence timer to 500nS, enables the output drivers disabled on timeout, and returns the settings:
SHORT nState;
SHORT nStatus;
DOUBLE dTimeoutValue;
GtDio6xSetSequencerTimer(nHandle, 500nS, GTDIO6X_ENABLED, &nStatus);
GtDio6xGetSequencerTimer(nHandle, &dTimeoutValue, &nState, &nStatus);
GtDio6xTimerGetSequencerTimeout, GtDio6xGetErrorString