Command |
Description |
Connect/Disconnect |
|
Connect Resource Resource |
Connects a Resource to a Resource. |
Connect Resource Channel |
Connect Resource to a UUT channel pin. |
Connect Channel Channel |
Connects a UUT channel pin to another UUT channel pin. |
Disconnect Bus |
Disconnect all connections to this bus. |
Disconnect Resource |
Disconnect all connections to this resource. |
Disconnect Resource Resource |
Disconnect this resource from the specified resource. |
Disconnect Resource Channel |
Disconnect this resource from the specified channel. |
Disconnect Channel |
Disconnect all connections to this channel. |
Disconnect Channel Channel |
Disconnect this channel from the specified channel. |
Reset All |
Opens all relay on all cards and clears any interrupts. |
Setup |
|
Setup Card Map |
Maps the specified slot number to the next available card number, returns the assigned card number. |
Setup Resource Name |
Set resource name. |
Setup Resource PreferredBus |
Sets a preferred bus to be used in connection to a particular resource. |
Setup Resource Map |
Maps resource channel to a logical name. |
Setup Log Clear |
Clears the SwitchEasy Windows event log. |
Setup Log On |
Turns the SwitchEasy Windows event logging on. |
Setup Log Off |
Turns the SwitchEasy Windows event logging off. |
Setup Channel Group |
Maps UUT pins to a UUT pin group. |
Setup Channel Map |
Maps a UUT channel to a logical name. |
Setup Channel Remove |
Removes mapping of the specified UUT Pin or UUT pin group. |
Setup Channel Remove All |
Removes mapping of all UUT pins and groups. |
Get |
|
Get Resource Name |
Get resource's name. |
Get Resource PreferredBus |
Get Resource's preferred bus. |
Get Channel Count |
Return number of UUT channels within your current switching domain based upon how many cards you have mapped. |
Get Channel Name |
Returns the UUT Channel Pin Name. |
Get Relay Count |
Returns the total number of relay openings/closures that have occurred. The count for each relay is accumulated throughout the life of a board. |
Get Relay States |
Returns the state of each relay. The index of an array element specifies its relay designation minus 1.For example, index 0 corresponds with relay K1, index 256 corresponds with relay K257. |
Get Connections State |
Returns the current connection status of the switching system. All types or a type (resources or channel) of connection can be specified. |
Get Slot Information |
Return True if switching card is installed at the specified slot. |
Get Slot Summary |
Returns the board summary (including model, SN, firmware version) for the board plugged into the specified slot. |
Panel |
Shows the Switch Easy Panel. |
Utility |
|
Utility BIT Abort |
Aborts the Built In Test. |
Utility BIT GetStatus |
Returns Built in Test Status. |
Utility BIT Run |
Starts a Built In Test. |
Utility Interrupt Disable |
Disable PCI interrupt. |
Utility Interrupt Resume |
Resume PCI interrupt. |
Utility Interrupt Reset |
Reset interrupt source. |
Utility Interrupt Setup |
Configures the behavior of the interrupts. |
Utility PIO Set Output Data |
Set the PIO Output Data. |
Utility PIO Set Output Enable |
Set the PIO Output Enable. |
Utility PIO Get Input Data |
Reads the PIO Input. |
Utility PIO Get Output Data |
Returns the PIO Output Data. |
Utility PIO Get Output Enable |
Returns the PIO Output Enable. |
Utility SaveRelayCountToEeprom |
Save relay count values to the EEPROM. |
Switch Easy driver commands