0	CALIBRATE FLATNESS
1	Position the Power Meter Switch in B
2	Position the Power Meter Switch in A
3	Press Peak Power Meter Anritsu :\r\n-SYSTEM\r\n-more - more\r\n-Rear Panel\r\n-GPIB\r\n-MODE - MODE
4	You must see :\r\nEMULATION MODE : HP437B
5	Press Peak Power Meter Anritsu :\r\n-SYSTEM\r\n-more - more\r\n-Rear Panel\r\n-GPIB\r\n-MODE - MODE - MODE
6	You must see :\r\nEMULATION MODE : ML24XX
7	Connect the MA2468A Power sensor to port 1.
8	Remove the connections
9	Bad Flatness calibrating :\r\nYou must calibrate a good flatness !
10
11
12	ONE dB COMPRESSION POINT CALIBRATING
13	Connect the MA2468A Power Sensor to port 2.
14	Connect  the power sensor behind the input circulator via the BECLER connector\r\n and\r\n the output of Generator 1 to input circulator.
15
16	NOISE FIGURE ANALYSER CALIBRATING
17	Connect the N4001A Noise Source to 50 Ohms Input.
18	Disconnect the N4001A Noise Source.
19
20	Connect cable W43 to port1 and W44 to port2.
21	
22	Connect the strap connector between J2 and J3 of the NETWORK ANALYZER 1 Front Panel.
23	Connect the strap connector between J4 and J5 of the NETWORK ANALYZER 1 Front Panel.
24	Connect the strap connector between J1 and J2 of the NETWORK ANALYZER 1 Front Panel.
25	Connect the strap connector between J3 and J6 of the NETWORK ANALYZER 1 Front Panel.
26	Connect the strap connector between J7 and J4 of the NETWORK ANALYZER 1 Front Panel.
27	Connect the strap connector between J5 and J8 of the NETWORK ANALYZER 1 Front Panel.
28	Switch Down 'S1 Switch' from the ATTENUATION CHAIN BOX 
29	Switch Up 'S1 Switch' from the ATTENUATION CHAIN BOX 
