Conditions Commands

Use the commands on ATEasy's Conditions menu to set different run modes, to set conditions upon failures, and to set Log Failures only condition. The Conditions menu contains the following commands:

Commands	Description
Continuous	Changes the run mode to Continuous mode.
Task By Task	Changes the run mode to Task By Task mode.
Test By Test	Changes the run mode to Test By Test mode.
Pause On Task Failure	Pauses the application when a Task fails.
Pause On Test Failure	Pauses the application when a Test fails.
Prompt On Pause Failure	Put up a prompt upon failure to allow: Abort, Retry, Ignore, Pause
Log Failures Only	Only log those tests/tasks that failed.
Repeat Run	Repeats the current program run.