Gx6384Open

Name

Type

Comments

nHandle

SHORT

Handle to a GX6384 board.

nGroup

SHORT

If the Switch Matrix is configured as two groups with 32 columns (default configuration) Group numbers are:

0. GX6384_GROUP_A

1. GX6384_GROUP_B

If the Switch Matrix is configured as one group with 64 columns the only Group is:

0. GX6384_GROUP_A

nRow

SHORT

Row numbers are:

0. GX6384_ROW_0: row number 0 (all models).

1. GX6384_ROW_1: row number 1 (all models).

2. GX6384_ROW_2: row number 2 (models Gx6384-2 and Gx6384-3 only).

3. GX6384_ROW_3: row number 3 (models Gx6384-2 and Gx6384-3 only).

4. GX6384_ROW_4: row number 4 (Gx6384-3 only).

5. GX6384_ROW_5: row number 5 (Gx6384-3 only).

nColumn

SHORT

Specified column relay number is as follows:

0-31: Switch Matrix is configured as two groups with 32 columns (default configuration).

0-63: Switch Matrix is configured as single group with 64 columns.

pnStatus

PSHORT

Returned status: 0 on success, negative number on failure.

Caution - The flexibility provided by the switch matrix means that any point could be connected to any other point. Extreme care should be observed when developing the control software to prevent shorts between low-impedance sources (such as power supplies). A typical method to prevent such shorts is to use a resistor in series between the power supplies and the switch matrix if these signals are for measurement purposes only. Before closing a relay, verify that no other low-impedance source is connected to the same Row/Column.